The use of sprocket is very extensive, so the sprocket needs to be maintained and maintained after being used for a long time. How to do it?

1. The tightness of the sprocket needs to be appropriate, a warm reminder that too tight will increase power consumption, and the shaft will be easily worn; but too loose the sprocket will easily jump and fall off the chain.

2. The sprocket cannot swing and skew when installed on the shaft. If the deviation of the two wheels is too large, it is easy to cause chain disconnection and accelerated wear.The editor reminds you to check and adjust the offset when replacing.

3. After the sprocket is severely worn, it should be replaced with a new sprocket at the same time to ensure good meshing.

4. The new sprocket is too long or stretched after use, it is difficult to adjust, it depends on the situation, but the requirement is an even number.

5. The sprocket should be filled with lubricating oil in time during work. Lubricating oil must enter the matching gap between the roller and the inner sleeve to change the working conditions and reduce wear.

6. The old sprocket cannot be mixed with part of the new sprocket. The editor reminds everyone that it will easily cause an impact in the transmission. Pull the sprocket.

7. When the machine is stored for a long time, remember to remove the sprocket and clean it with kerosene or diesel. Then coat it with oil or butter and store it in a dry place.