If we want a product that can be used for a long time, we need to maintain and maintain it on a daily basis. Therefore, how to extend the service life of the sprocket?The details are as follows:

1. The tightness of the sprocket should be suitable. Too tight will increase a power consumption. The bearing structure is simply analyzed for wear. Too loose sprocket through simple beating and unchaining. The tightness of the sprocket is about two sprocket centers The distance is 2-3.

2. The sprocket should not be translated or tilted when installed on the shaft.The end faces of the two sprockets in the same system transmission technology component should be located in the same control plane in China. When the sprocket design center distance is less than 0.5 meters, the error can be 1 mm; when the sprocket machining center distance is more than 0.5 meters. Able to pass the error 2 mm.However, the conflict can not be the phenomenon of sprocket tooth surface. Large chain stores only produce accelerated wear and tear. If it is too much to offset the two.

3. The sprocket wear is very serious, it should be replaced with a new sprocket and a new chain at the same time to ensure good meshing. Not just a single new replacement sprocket, otherwise it will result in the formation of a poor meshing to accelerate the new sprocket or Wear of new sprocket.Should be handed over to use (refer to the side of the adjustable sprocket) when the rear sprocket is worn to a certain extent, in order to extend the operating time.

4. The new sprocket is too long or can be stretched after being used. It is difficult to adjust, you can remove the chain link depending on the situation. But it must be an even number. The chain should pass through the reverse side of the sprocket, and the lock should be inserted outside. The opening should roll in the opposite direction.

5. The working sprocket should be filled with lubricating oil in time.It is necessary for the lubricating oil to enter the cooperative learning gap between the roller and the inner sleeve to improve the management of working environment conditions and reduce wear.

6. It is not allowed to mix the new sprocket and the old parts of the sprocket, or just the impact of the drive and the broken sprocket.

7. When the machine is stored for a long time. The sprocket should be removed and cleaned with kerosene or diesel. Then it is coated with oil or butter and stored in some boring place.